Difference between revisions of "Contrib/MakeAxialMesh"

From OpenFOAMWiki
(Usage)
Line 23: Line 23:
 
deforms it so that the faces on the axis become zero size (rectangles
 
deforms it so that the faces on the axis become zero size (rectangles
 
with one side of zero area). The collapseEdges utility should remove these
 
with one side of zero area). The collapseEdges utility should remove these
degenerate edges (and the faces that go with it) and stitch the mesh together.
+
degenerate edges (and the faces that go with it) and stitch the mesh together.  For an application like this,
 +
you would want to use collapseEdges with a very small length scale argument and an angle argument near 180 degrees.
  
 
== Example ==
 
== Example ==

Revision as of 19:48, 24 July 2006

Valid versions: OF version 13.png

1 Short description

Creates an axial-symmetric grid from a two-dimensional grid

2 Usage

Needs two inputs:

  1. name of the boundary that is the symmetry axis
  2. name of the boundary that is to be split into two wedge-boundaries (front and back)

The code assumes the following about the grid:

  • 2D-Grid (just one cell thick)
  • the axis of symmetry parallel to the XY-plane
  • the boundary that is the symmetry axis is a straight line
  • the "front" and "back" are one patch

The type of the axis-patch is set to empty, the type of the newly created patches to wedge.


To complete the construction of your axisymmetric mesh, you must next use the collapseEdges utility to remove the faces at the symmetry axis. The makeAxialMesh code doesn't manipulate the topology of the mesh, but only deforms it so that the faces on the axis become zero size (rectangles with one side of zero area). The collapseEdges utility should remove these degenerate edges (and the faces that go with it) and stitch the mesh together. For an application like this, you would want to use collapseEdges with a very small length scale argument and an angle argument near 180 degrees.

3 Example

The original mesh
The converted mesh


The original mesh had (amongst others) these faces:

center 
The face that is to be collapsed an turned into a symmetry axis (at the bottom in the picture on the left)
frontAndBackPlanes 
The patch that contains the front and the back face and will be split into two patches)

The command

makeAxialMesh . testAxial2 center frontAndBackPlanes

converts this into the mesh seen in the picture on the right.

4 Download

The tar file with the sources. Works only for OpenFOAM 1.3.

5 History

This utility was discussed in this thread on the Message Board.

  • 2006-03-28: New version which fixes a bug if the axis is not the whole length of the grid (fix provided by E David Huckaby)

Types of the newly created patches are set

  • 2006-04-03: New Version that works under OpenFOAM 1.3. Removes a bug that was introduced in the last version.

--Bgschaid 14:13, 31 May 2005 (CEST)