Difference between revisions of "Installation/Linux/foam-extend-3.0/Fedora"

From OpenFOAMWiki
Line 17: Line 17:
 
Run the following commands:
 
Run the following commands:
 
<bash>sudo yum groupinstall "Development Tools"
 
<bash>sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel cmake bison flex m4 zlib-devel \
+
sudo yum install gcc-c++ binutils-devel cmake wget bison flex m4 zlib-devel \
 
qt-devel qtwebkit-devel mercurial graphviz
 
qt-devel qtwebkit-devel mercurial graphviz
 
</bash>
 
</bash>

Revision as of 15:25, 17 June 2014

1 Introduction

This page is dedicated to preparing a Fedora system for installing the foam-extend project OF Version 30ext.png.


2 Fedora versions

2.1 Fedora 19

Run the following commands:

sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz

2.2 Fedora 20

Run the following commands:

sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel cmake wget bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz


Then continue following the instructions on the previous page, subsection Get the source code.