Difference between revisions of "Installation/Linux/foam-extend-3.0/openSUSE"
From OpenFOAMWiki
< Installation | Linux | foam-extend-3.0
(Revamped page for making it an openSUSE system preparation page) |
(→openSUSE 13.1: added missing instruction) |
||
| Line 18: | Line 18: | ||
{{Installation/Linux/ExitRoot}} | {{Installation/Linux/ExitRoot}} | ||
</ol> | </ol> | ||
| + | |||
| + | Then continue following the instructions on the previous page, subsection [[Installation/Linux/foam-extend-3.0#Installing from source code|Get the source code]]. | ||
[[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on openSUSE]] | [[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on openSUSE]] | ||
Revision as of 15:03, 15 June 2014
1 Introduction
This page is dedicated to preparing an openSUSE system for installing the foam-extend project 
.
2 openSUSE versions
2.1 openSUSE 13.1
Follow these steps:
- Switch to root mode (administrator), to install the necessary packages:
sudo -s
- If the 'sudo' command tells you're not in the sudoers list, then run:
su -
- If the 'sudo' command tells you're not in the sudoers list, then run:
- Install the necessary packages:
zypper install git openmpi-devel gnuplot -t pattern devel_qt4
- Now exit from the root mode:
exit
Then continue following the instructions on the previous page, subsection Get the source code.
