Installation/Linux/foam-extend-3.0/openSUSE
From OpenFOAMWiki
< Installation | Linux | foam-extend-3.0
1 Introduction
This page is dedicated to preparing an openSUSE system for installing the foam-extend project .
2 openSUSE versions
2.1 openSUSE 13.1
Follow these steps:
- Switch to root mode (administrator), to install the necessary packages:
sudo -s
- If the 'sudo' command tells you're not in the sudoers list, then run:
su -
- If the 'sudo' command tells you're not in the sudoers list, then run:
- Install the necessary packages:
zypper install git openmpi-devel gnuplot -t pattern devel_qt4
- Now exit from the root mode:
exit
Then continue following the instructions on the previous page, subsection Get the source code.