Difference between revisions of "Installation/Linux/foam-extend-3.1/Ubuntu"

From OpenFOAMWiki
(Ubuntu 12.04)
(Ubuntu 14.04)
Line 25: Line 25:
 
Run the following command:
 
Run the following command:
 
<bash>sudo apt-get update</bash>
 
<bash>sudo apt-get update</bash>
<bash>sudo apt-get install git-core build-essential binutils-dev flex \
+
<bash>sudo apt-get install git-core build-essential binutils-dev cmake flex \
 
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev\
 
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev\
 
libxt-dev rpm mercurial graphviz
 
libxt-dev rpm mercurial graphviz

Revision as of 13:36, 3 September 2014

1 Introduction

This page is dedicated to preparing an Ubuntu system for installing the foam-extend project OF Version 31ext.png.


2 Ubuntu versions

2.1 Ubuntu 12.04

Run the following command:

sudo apt-get update
sudo apt-get install git-core build-essential binutils-dev flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev \
libxt-dev rpm mercurial graphviz

Then continue following the instructions on the previous page, subsection Get the source code.

2.2 Ubuntu 13.10

Follow the same steps as in Ubuntu 12.04.


2.3 Ubuntu 14.04

Run the following command:

sudo apt-get update
sudo apt-get install git-core build-essential binutils-dev cmake flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev\
libxt-dev rpm mercurial graphviz

Then continue following the instructions on the previous page, subsection Get the source code.