Difference between revisions of "Installation/Linux/foam-extend-3.1/Ubuntu"

From OpenFOAMWiki
(Ubuntu 14.04)
m (Ubuntu 14.04: fixed typo)
Line 26: Line 26:
 
<bash>sudo apt-get update</bash>
 
<bash>sudo apt-get update</bash>
 
<bash>sudo apt-get install git-core build-essential binutils-dev cmake flex \
 
<bash>sudo apt-get install git-core build-essential binutils-dev cmake flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev\
+
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev \
 
libxt-dev rpm mercurial graphviz
 
libxt-dev rpm mercurial graphviz
 
</bash>
 
</bash>

Revision as of 20:08, 4 February 2015

1 Introduction

This page is dedicated to preparing an Ubuntu system for installing the foam-extend project OF Version 31ext.png.


2 Ubuntu versions

2.1 Ubuntu 12.04

Run the following command:

sudo apt-get update
sudo apt-get install git-core build-essential binutils-dev flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev \
libxt-dev rpm mercurial graphviz

Then continue following the instructions on the previous page, subsection Get the source code.

2.2 Ubuntu 13.10

Follow the same steps as in Ubuntu 12.04.


2.3 Ubuntu 14.04

Run the following command:

sudo apt-get update
sudo apt-get install git-core build-essential binutils-dev cmake flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev \
libxt-dev rpm mercurial graphviz

Then continue following the instructions on the previous page, subsection Get the source code.