Installation/Linux/foam-extend-3.1/Ubuntu

From OpenFOAMWiki

1 Introduction

This page is dedicated to preparing an Ubuntu system for installing the foam-extend project OF Version 31ext.png.


2 Ubuntu versions

2.1 Ubuntu 12.04

Run the following commands:

sudo apt-get update
sudo apt-get install git-core build-essential binutils-dev flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev \
libxt-dev rpm mercurial graphviz

Then continue following the instructions on the previous page, subsection Get the source code.

2.2 Ubuntu 13.10

Follow the same steps as in Ubuntu 12.04.


2.3 Ubuntu 14.04

Run the following commands:

sudo apt-get update
sudo apt-get install git-core build-essential binutils-dev cmake flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev \
libxt-dev rpm mercurial graphviz

Then continue following the instructions on the previous page, subsection Get the source code.

2.4 Ubuntu 16.04

Run the following commands:

sudo apt-get update
sudo apt-get install git-core build-essential binutils-dev cmake flex \
zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev \
libxt-dev rpm mercurial graphviz python python-dev

Then follow the instructions on the previous page, subsection Get the source code.

Note: Before running Allwmake.firstInstall, you will need to run the following command to fix an issue with the Flex version:

find src applications -name "*.L" -type f | xargs sed -i -e 's=\(YY\_FLEX\_SUBMINOR\_VERSION\)=YY_FLEX_MINOR_VERSION < 6 \&\& \1='