View source for Installation/Linux/foam-extend-3.1/Fedora

= Introduction =
This page is dedicated to preparing a [http://fedoraproject.org Fedora] system for installing {{-Extend}} {{version3.1-ext}}.

__FORCETOC__
__TOC__

= Fedora versions =

== Fedora 19 ==
Run the following commands:
<bash>sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz
</bash>

Then continue following the instructions on the previous page, subsection [[Installation/Linux/foam-extend-3.1#Installing from source code|Get the source code]].


== Fedora 20 ==
Run the following commands:
<bash>sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel cmake wget bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz
</bash>

Then continue following the instructions on the previous page, subsection [[Installation/Linux/foam-extend-3.1#Installing from source code|Get the source code]].

[[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on Fedora]]