Difference between revisions of "Installation/Linux/foam-extend-3.0/Arch Linux"
m (→Introduction: fixed typo) |
(Removed links to the Manjaro instructions, as they are gone.) |
||
Line 37: | Line 37: | ||
Once virtualenv and rpm-org are installed and virtualenv is activated as shown above, follow the [http://openfoamwiki.net/index.php/Installation/Linux/foam-extend-3.0 tutorial] that shows how to build foam-extend on Linux, the rest of the steps are exactly the same as shown there. | Once virtualenv and rpm-org are installed and virtualenv is activated as shown above, follow the [http://openfoamwiki.net/index.php/Installation/Linux/foam-extend-3.0 tutorial] that shows how to build foam-extend on Linux, the rest of the steps are exactly the same as shown there. | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
[[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on Arch Linux]] | [[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on Arch Linux]] |
Revision as of 12:55, 15 June 2014
Contents
1 Introduction
Arch Linux is a rolling source-based distribution. It has an official package manager called 'pacman' and its extension 'yaourt' that installs community contributed software packages. The packages installed in this distribution are source-code based, which means that the distribution always gives access to the newest software versions. This can cause some problems when building and installing foam-extend, as for example PyFoam has been ported to Python 3 (see) but not been tested under working conditions.
2 Installing rpm-org
Install rpm-org, and remove rpm if you have it already installed.
yaourt -R rpm yaourt -S rpm-org
3 Installing and configuring virtualenv python virtual environment
Arch uses Python 3.*, and foam-extend relies on Python 2.*. To easily switch between python versions, virtualenv is recommended.
Install easy_install
yaourt -S python-setuptools
Install virtualenv:
sudo easy_install virtualenv
Configure the python2.7 environment for foamext:
virtualenv -p python2.7 --no-site-packages ~/env/foamext
Source the python2.7 environment for foamext:
source ~/env/foamext/bin/activate
4 Building foam-extend
Once virtualenv and rpm-org are installed and virtualenv is activated as shown above, follow the tutorial that shows how to build foam-extend on Linux, the rest of the steps are exactly the same as shown there.