Difference between revisions of "Installation/Linux/foam-extend-3.0/Fedora"

From OpenFOAMWiki
(Kicked off this page)
 
Line 13: Line 13:
 
qt-devel qtwebkit-devel mercurial graphviz
 
qt-devel qtwebkit-devel mercurial graphviz
 
</bash>
 
</bash>
 +
 +
== Fedora 20 ==
 +
Run the following commands:
 +
<bash>sudo yum groupinstall "Development Tools"
 +
sudo yum install gcc-c++ binutils-devel cmake bison flex m4 zlib-devel \
 +
qt-devel qtwebkit-devel mercurial graphviz
 +
</bash>
 +
  
 
Then continue following the instructions on the previous page, subsection [[Installation/Linux/foam-extend-3.0#Installing from source code|Get the source code]].
 
Then continue following the instructions on the previous page, subsection [[Installation/Linux/foam-extend-3.0#Installing from source code|Get the source code]].
  
 
[[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on Fedora]]
 
[[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on Fedora]]

Revision as of 15:06, 17 June 2014

1 Introduction

This page is dedicated to preparing a Fedora system for installing the foam-extend project OF Version 30ext.png.


2 Fedora versions

2.1 Fedora 19

Run the following commands:

sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz

2.2 Fedora 20

Run the following commands:

sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel cmake bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz


Then continue following the instructions on the previous page, subsection Get the source code.