Installation/Linux/foam-extend-3.0/Fedora

From OpenFOAMWiki
< Installation‎ | Linux‎ | foam-extend-3.0
Revision as of 19:21, 21 June 2014 by Wyldckat (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

1 Introduction

This page is dedicated to preparing a Fedora system for installing the foam-extend project OF Version 30ext.png.


2 Fedora versions

2.1 Fedora 19

Run the following commands:

sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz

Then continue following the instructions on the previous page, subsection Get the source code.


2.2 Fedora 20

Run the following commands:

sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel cmake wget bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz

Then continue following the instructions on the previous page, subsection Get the source code.