Difference between revisions of "Installation/Linux/foam-extend-3.0/Ubuntu"

From OpenFOAMWiki
(Revamped page for making it an Ubuntu system preparation page)
m (Ubuntu 14.04: fixed typo)
Line 29: Line 29:
 
Run the following command:
 
Run the following command:
 
<bash>sudo apt-get install git-core build-essential binutils-dev flex \
 
<bash>sudo apt-get install git-core build-essential binutils-dev flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev\
+
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev \
 
libxt-dev rpm mercurial graphviz
 
libxt-dev rpm mercurial graphviz
 
</bash>
 
</bash>

Revision as of 21:08, 4 February 2015

1 Introduction

This page is dedicated to preparing an Ubuntu system for installing the foam-extend project OF Version 30ext.png.


2 Ubuntu versions

2.1 Ubuntu 12.04

Run the following command:

sudo apt-get install git-core build-essential binutils-dev flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev \
libxt-dev rpm mercurial graphviz

Then create an additional link:

sudo ln -s /usr/bin/make /usr/bin/gmake

Then continue following the instructions on the previous page, subsection Get the source code.


2.2 Ubuntu 13.10

Follow the same steps as in Ubuntu 12.04.


2.3 Ubuntu 14.04

Run the following command:

sudo apt-get install git-core build-essential binutils-dev flex \
bison zlib1g-dev qt4-dev-tools libqt4-dev libncurses5-dev libiberty-dev \
libxt-dev rpm mercurial graphviz

Then create an additional link:

sudo ln -s /usr/bin/make /usr/bin/gmake

Then continue following the instructions on the previous page, subsection Get the source code.