View source for Talk:FAQLong

From OpenFOAMWiki


Thread titleRepliesLast modified
locationInMesh Error116:31, 1 January 2017

locationInMesh Error

Hi. I am trying to simulate a propeller with pimpleDyMFoam solver with a new geometry and domain. but at running the snappyHexMesh command, after some warnings, the following error appears:

    Point (-0.105003 0.02607 0.06072) is not inside the mesh or on a face or edge.
    Bounding box of the mesh:(-0.571 -0.3 -0.300002) (1.989 0.3 0.299998)
   From function Foam::labelList Foam::refinementParameters::findCells(const Foam::polyMesh&) const
   in file snappyHexMeshDriver/refinementParameters/refinementParameters.C at line 103.
   FOAM exiting

As you can see the point is in the bounding box and it is not inside the mesh or on a face or edge. please help me out.

Taghikhani (talk)12:24, 1 January 2017

You do not have permission to edit this page, for the following reasons:

  • The action you have requested is limited to users in the group: Users.
  • You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.
  • Your username or IP address has been blocked. The block was made by DNSBL. The reason given is Your IP address is listed as an open proxy in the DNSBL used by OpenFOAMWiki..
    • Start of block: 20:31, 23 June 2024
    • Expiry of block: 20:31, 23 June 2024
    • Intended blockee:
    You can contact DNSBL or another administrator to discuss the block. You cannot use the "email this user" feature unless a valid email address is specified in your account preferences and you have not been blocked from using it. Your current IP address is, and the block ID is #. Please include all above details in any queries you make.

You can view and copy the source of this page:

Return to Thread:Talk:FAQLong/locationInMesh Error/reply.