Difference between revisions of "Installation/Linux/foam-extend-3.0/Fedora"
From OpenFOAMWiki
< Installation | Linux | foam-extend-3.0
(Kicked off this page) |
|||
Line 13: | Line 13: | ||
qt-devel qtwebkit-devel mercurial graphviz | qt-devel qtwebkit-devel mercurial graphviz | ||
</bash> | </bash> | ||
+ | |||
+ | == Fedora 20 == | ||
+ | Run the following commands: | ||
+ | <bash>sudo yum groupinstall "Development Tools" | ||
+ | sudo yum install gcc-c++ binutils-devel cmake bison flex m4 zlib-devel \ | ||
+ | qt-devel qtwebkit-devel mercurial graphviz | ||
+ | </bash> | ||
+ | |||
Then continue following the instructions on the previous page, subsection [[Installation/Linux/foam-extend-3.0#Installing from source code|Get the source code]]. | Then continue following the instructions on the previous page, subsection [[Installation/Linux/foam-extend-3.0#Installing from source code|Get the source code]]. | ||
[[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on Fedora]] | [[Category:Installing OpenFOAM on Linux]] [[Category:Installing OpenFOAM on Fedora]] |
Revision as of 14:06, 17 June 2014
1 Introduction
This page is dedicated to preparing a Fedora system for installing the foam-extend project .
2 Fedora versions
2.1 Fedora 19
Run the following commands:
sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz
2.2 Fedora 20
Run the following commands:
sudo yum groupinstall "Development Tools"
sudo yum install gcc-c++ binutils-devel cmake bison flex m4 zlib-devel \
qt-devel qtwebkit-devel mercurial graphviz
Then continue following the instructions on the previous page, subsection Get the source code.